do not press the back button…
Enter your VAT number here and click Verify:
Your details have been verified. VAT number registered to:
,
.
Your order will now be zero rated for VAT purposes. We reserve the right to verify these details after your order request has been made and reinstate VAT if required.
Your VAT details were not recognised or were invalid. Your VAT number must be matched to your Billing Country as specified above. This is currently specified as . You do not need to enter the country code part of your VAT number as this has already been selected in your billing address details above.
The VAT number checking service is currently offline. Please supply your VAT details within the comments or special instructions field below and we will apply a VAT discount after placing your order request.
- Porsche 944 2.5L 8V 1982-87
- Porsche 944 2.7L 8V 1988-89
- Porsche 944S 2.5L 16V 1987-88
- Porsche 944S2 3.0L 16V 1989-91
- Porsche 944 Turbo 2.5L 8V 1985-88
- Porsche 944 Turbo 2.5L 8V 1989-91
- Porsche 944 Turbo S 2.5L 8V 1988
- Porsche 968 3.0L 1992-94
- Porsche 968 Sport 3.0L 1994-95
- Porsche 968 CS 3.0L 1993-95
- Porsche 968 Turbo S 3.0L 1993-94
Control arm mount (rear position)
Rear-position control arm mount by OE Match for Porsche 944 / 968 applications. This replacement rubber mounting supports repairs to the wishbone mounting assembly.
Sold individually, 2 required per vehicle
Fits
Porsche 944 1986>>
Porsche 968 1992 - 1995
Diagram ref no 10
What This Product Does
The mount provides a supported connection at the control arm's rear mounting position. Its rubber element allows compliant movement while helping limit unwanted movement at the attachment point. It is a mounting component rather than a complete wishbone.
Functions
- Supports the control arm at its rear attachment point.
- Provides compliance within the suspension connection.
- Helps isolate vibration passing through the mounting point.
Technical Details
- Brand: OE Match.
- Supplied reference: 95134102301.
- Position: rear mounting point of the control arm.
- Diagram assembly: Wishbone / Cross member 968 1992–95.
- Two mountings is required per car, Supplied individually
Symptoms of Fault
- Knocks or clunks when travelling over uneven surfaces.
- Steering that feels vague or requires repeated correction.
- Vibration or pulling during braking.
- Irregular tyre wear.
- Visible rubber deterioration or excessive movement at the mounting.
These signs can also arise from other suspension components. Inspect the bushes, joints and adjoining fixings to establish the cause before replacing the mount.
Why Replacement Matters
A deteriorated mounting can allow the arm to move more than intended, affecting the consistency of suspension geometry. Replacing a confirmed worn component addresses that mounting point during a suspension repair or restoration. OE Match develops replacement components around Porsche applications, using reference and fitment checks as part of its selection process.
FAQs
Is this a complete control arm?
No. It is the rear-position mounting component.
Should the opposite mounting be inspected?
Yes. Assess both sides and associated components, then replace according to their condition.
Is an alignment check needed?
Arrange a geometry check after work that affects the control arm position.
What should be checked before fitting?
Compare the original reference and mounting arrangement, inspect the fixings, and follow the vehicle-specific installation procedure.
Related reference numbers
Related, superseded, cross reference or alternative numbers for comparison.
95134102301
The product you are viewing cross references to these numbers