do not press the back button…
Enter your VAT number here and click Verify:
Your details have been verified. VAT number registered to:
,
.
Your order will now be zero rated for VAT purposes. We reserve the right to verify these details after your order request has been made and reinstate VAT if required.
Your VAT details were not recognised or were invalid. Your VAT number must be matched to your Billing Country as specified above. This is currently specified as . You do not need to enter the country code part of your VAT number as this has already been selected in your billing address details above.
The VAT number checking service is currently offline. Please supply your VAT details within the comments or special instructions field below and we will apply a VAT discount after placing your order request.
- Porsche 911 1968-1973 2.2L / 2.4L / 2.7L RS LWB (F)
- Porsche 911 1974-1977 2.7L / 1976-77 3.0 Carrera
- Porsche 914 (1970-1976)
OE Match front axle cross member for the listed Porsche 911 applications and 914. The heat-treated magnesium casting includes brackets and requires two rear-arm holes to be drilled during installation.
Fits
- Porsche 911 2.7RS / 2.8 RSR / 2.5ST / 3.0 934
- Porsche 911 1968–1973 2.2L / 2.4L / 2.7L RS LWB (F)
- Porsche 911 1974–1977 2.7L / 1976–77 3.0 Carrera
- Porsche 914 1970–1976
Check fitment for your specific vehicle (model, year, engine) before ordering.
What This Product Does
The cross member provides structural support within the front axle assembly, helping locate the attached suspension components and maintain their mounting geometry. It is intended for replacement or restoration work where the existing component needs renewal.
Functions
- Supports components attached to the front axle assembly.
- Maintains the relationship between suspension mounting points.
- Transfers loads through the front chassis structure.
Technical Details
- Construction: cast magnesium.
- Treatment: temperature hardening.
- Brackets are included with the cross member.
- The two holes needed for the rear arms must be made when fitting; this is not a fully pre-drilled installation.
- Supplied diagram records identify reference 91134103101 as a strut rather than the complete cross member. Confirm the required assembly and reference before fitting.
Diagram References
Diagram reference number: 2
Symptoms of Fault
- Visible cracks, deterioration or impact distortion.
- Knocking associated with loose or damaged mounting points.
- Persistent alignment discrepancies or unusual tyre wear.
- Movement around the front suspension attachments.
These symptoms can also originate in bushes, joints or fixings. Inspect the assembly before deciding which component requires replacement.
Why Replacement Matters
Damage or deterioration can alter the position and support of connected components. Replacement addresses the affected structure, while inspection of adjoining brackets, mounting surfaces and fasteners helps identify related faults.
FAQs
Is drilling necessary?
Yes. The two rear-arm mounting holes must be produced during installation.
Should alignment be checked afterwards?
Arrange a geometry check following work that disturbs suspension mounting positions.
What else should be inspected?
Check associated bushes, brackets, bolts and chassis mounting areas. Have a competent technician confirm fitment and carry out the drilling and installation.
Related reference numbers
Related, superseded, cross reference or alternative numbers for comparison.
91134103101
The product you are viewing cross references to these numbers